Putting Up Drip Edge On Trim Siding

Apply a continuous bead of cement along the top of the drip edge then press down on the shingle.

Putting up drip edge on trim siding.

Cut along the corner of the facing edge. Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge. When installing the starter strips allow a 1 8 inch space for corner posts and j channels for expansion. Secure the drip edge with roofing cement.

This is important to protect damage to your fascia soffits rafters. At the bottom make a 1 in. Slide the corner tight to the fascia. To seal the edge of a siding panel where it has been cut and to secure it to the wall you can use under sill trim.

Find your most beat up pieces of siding and rip them down into 1 1 4 in. The drip leg is at least 3 4 in. Installing drip edge on your roof. Nail in the center of the nailing slots.

Place a nail at one end then the other. Slide the overlapping corner under the other overhanging piece of drip edge. Keep ends of adjoining starter strips at least 1 4 inch apart to allow for expansion. Cut the overlapping piece with the top edge to fit square against the end of the roof and the overhanging edge to fold around the corner.

Above the bottom of the wall sheathing as a guide. As seen in m. Tools supplies tin sn. And i include a 1 4 in.

Create a drip edge. Get the real story about drip edge placement. If necessary secure the ends of the drip edge with short roofing nails. Outward kick along the bottom.

You may need to nail through the starter strip into the drip edge. These strips installed at the bottom will make your first row of siding angle out to match the rest of the rows. Install these fragile starter strips with a 15 gauge. Does the drip edge metal go under the tarpaper ice and water shield or underlayment on the eave.

Cut one piece of drip edge square on both edges to fit against the end of the roof. Just be sure they re positioned high up under the shingles. Snap a line 1 in.