Pvc Coating On Sheet Metal

Jm pvc coated metal.

Pvc coating on sheet metal.

Even the largest diameter ducts are easily cut with portable metal cutting saber saws or circular saws. Use for metal gravel stops and drip edges metal base and curb flashings and sealant pans and scupper sleeves. 4 4 has a 4 mil coating of polyvinyl chloride on both sides. Pvc coating or a thin bonded piece of pvc can be applied to any sheet or coil product to help protect the surface from scratches or other damage during shipment incoming inspection and possibly manufacture of part.

The coating lightly adheres to the surface of the sheet or coil and is easily removed without any deleterious impact on the sheet or coil product. Plastisol sheeting is a very high quality galvanised steel sheet with a primer paint and the pvc rolled onto it giving a very durable sheet that doesn t fade or scratch easily and with an expected lifespan of 30 years. It gives maximum interior and exterior protection. Valgro understands the importance of the surface protection operations and has been the industry standard for sheet metal lamination machines wood laminating system and protective tape film lamination machines for many years.

Plastic and wood surfaces often require film coatings to protect the surface as well. Jm pvc membrane laminated with galvanized steel to be fabricated into metal flashings and edge details. When tested class 0 in accordance with building regulations bs476 part 6 1989 and part 7 1987. Pvc coated metal is cut into the appropriate width and used to fabricate metal drip edges or other roof perimeter edging profiles.

It is used to provide monolithic water tight protection for both adhered and mechanically fastened roofing assemblies. Sheet metal coils. Available in hundreds of colors aluminum casing trim is economical and provides a durable low maintenance finish. Pvc plastisol coated sheets are recommended for roofing due to there durability.

Fabricated by the contractor into metal flashings and edge details. A pvc un reinforced membrane laminated to galvanized sheet metal cuts and forms like standard sheet metal. A 24 gauge galvanized steel sheet coated with a layer of 0 035 non reinforced pvc flashing. 4 1 reverse a more economical system has the 4 mil coating on the inside and a grey wash coat on the outside for jobs where extra protection is not needed for the outside of the duct system.

It can be cut and formed with regular sheet metal equipment and tools with no harm to the coating. Pvc ductwork has also passed thousands of accelerated salt spray and humidity cabinet tests with no loss of adhesion or corrosion resistance. Field and flashing membranes heat weld directly to the coated metal.