All radon mitigation installation standards require that the radon fan be located outside the living space of the home.
Radon fan in the basement or attic.
Of clean size 4 6 gravel to very loose soil.
The location of the radon fan.
If you have a radon level of around 4pci l the level of radon being pushed out of the exhaust side of the fan can be many times higher even into the 100s.
The radon system is hidden.
Or closet and then run the pipe along the exterior of the home with the fan placed right up against the outside of the home.
This is required of a radon mitigation system as it protects you from a leak at the site of the fan which would result in a pooling of radon as the fan pulls radon up but then fails to expel it from.
Using a rotary hammer drill a hole in the basement slab large enough to receive a 3 inch plastic pipe.
Radon fans inside attic spaces are better protected from the freeze and thaw cycle.
Radon fans are better protected from the elements.
Beyond a certain level the epa recommends a fan powered suction system to evacuate radon from the house.
They will need to access all areas of the basement along with the garage and attic areas.
Instead of having the fan and venting pipes on the outside of the home the only visible component on the outside is the vent stack that rises through the roof.
The radonaway rp145c radon fan is built to resist moisture and can be mounted inside or outside on a 3 in.
Many homeowners with a finished basement are concerned about the radon mitigation process.
The air flowing through the fan will maintain the fan temperature.
If the radon fan is located in the attic of the house or garage you can wrap the fan with fiberglass insulation.
In the attic in the garage or outside least preferred.
Make a hole.
I have never found a radon fan more than a bit warm even if the motor has been stalled by some blockage so there appears to be no concern about causing a fire from.
Electrical components are out of reach.
The purpose of a radon fan is to draw radon from out of the soil below the home and release it safety above the house.
In cold environments this condensation can freeze and effect the life of the radon vent fan.
Radon fans and electrical components are out.
The reasoning for this is that if a leak was to occur above the fan your house could have a really high radon level.
You will need to place the fan such that it is outside the living area of your house.
Schedule 40 pvc vent pipe using 3.
Radon fan location why is the basement not a proper radon fan location.
Related how to test for radon and get rid of it.
When a radon system is installed in the attic space the fan and all electrical components are also located in the.
Fans placed in attics garages and outside locations will keep you safe.